No access with Cisco Aironet 702i AIR-SAP702I-A-K9

[anthony.belliot]

Hi,

I have bought AIR-SAP702I-A-K9  and I have started it.

I can find this IP, I can ping it, but not access (http/80 or telnet or ssh)...

Is the access point is KO ?

In getting started guide, it says the AP search controller but I have not controller, i want to use the AP an autonomous...

I tried to reset the AP from 2 times, but same problem ...

Any idea.

Thanks

[Leo Laohoo · Accepted solution]

You really need a console cable to start putting config on an autonomous AP.  

It's not dead.  

[William Kuczmera · Accepted solution]

APs ship with lightweight code. You need to convert your ap to autonomous.

The preso below may be helpful for you. 

https://supportforums.cisco.com/video/11928901/lwapp-lightweight-mode-autonomous-conversion-and-vice-versa

[anthony.belliot]

Thanks,

I have download the autonomous firmware and upload it with tftp with mode button.

now it's ok.

I go to bed less stupid... ;)

[Scott Fella]

+5 Will

Glad to see you posting on the forums Will, along with your very first 5 points and correct answer!

-Scott