Hi Experts! So I'm trying to get a power profile with
EWC9800#show ap name my-ap power-profile summary
AP power derate Capability : Capable
Power profile type : Calendar
AP power save mode : Enabled
Power saving mode profile : low-power
Associated calendar profile : NightTime
AP power profile status : Success
Interface Interface-ID Parameter Parameter value Status
---------------------------------------------------------------------------------------
Ethernet Gig0 Speed 100 MBPS Success
Radio 2.4 GHz Spatial Stream 1 x 1 Not Applied
Radio 5 GHz State DISABLED Success
Radio Sec 5 GHz State DISABLED Success
USB USB0 State DISABLED Success
So I have a few questions -
what is "not applied", here? And yesterday, during the time that this was supposed to be applied, 5Ghz was working like a boss whereas it should have not been working. And for another one, it's `Not Applied` for the 5Ghz.
EWC9800#show ap name my-ap2 power-profile summary
AP power derate Capability : Capable
Power profile type : Calendar
AP power save mode : Enabled
Power saving mode profile : low-power
Associated calendar profile : NightTime
AP power profile status : Success
Interface Interface-ID Parameter Parameter value Status
---------------------------------------------------------------------------------------
Ethernet Gig0 Speed 100 MBPS Success
Radio 2.4 GHz Spatial Stream 1 x 1 Success
Radio 5 GHz State DISABLED Not Applied
Radio Sec 5 GHz State DISABLED Success
USB USB0 State DISABLED Success
So... all of them were at 100 MBPS (vs 5GBps during day time) but I was able to use it at 400+Mbps. What am I missing? I have 4 APs in my setup, only one has 5 "Success" status in the table above. But all still have a phy link to the switch A-5000, so not sure if this is supposed to renegotiate for 100 Mbps instead. But clearly the 5Ghz radio still works as this is what I'm writing from.
How can I see why/where this is being seemingly ignored?
