Hello,
I like to configure 3 Cisco WAP4410N as repeaters for every floor of an office. The adsl router is a Cisco WAG120N. I upgrade firmware to 2.0.2.1 WAP4410N.
- I have one of the WAP4410N (1) connect to the Router Cisco WAG120N, configured like access point.
- In the second floor i put another WAP4410N (2) as bridge. (unwired)
- In the third floor i try to put the last WAP4410N (3) but i don't know how to setup it. I only see the second WAP4410N, not the access point one. I try to connect to the WAP4410N (2), but then it don't give me an ip address, dhcp on the network is on. If i configure a fix ip it don't works neither..
The only WAP4410N that is wired to the router is the (1), (2) and (3) must be repeaters unwired.
Thanks for your help.
