cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
644
Views
0
Helpful
2
Replies

Updated controller but not showing right version

polleyjb01
Level 1
Level 1

I just updated my 4404 controller with 7.0.116.0.

After I rebooted and check the version number on the monitor page, it tells me its still version

7.0.98.0. The weird thing is, is that the Emergency Image Version is what changed to version 7.0.116.0.

2 Replies 2

George Stefanick
VIP Alumni
VIP Alumni

Check your swapped image: Check the WLC part towards the bottom. This will be a place to start ..

Iblogged about this a bit ago ..

http://www.my80211.com/cisco-wlc-cli-commands/

Controller and Access Point Image Swap

Access Point - Swapping the image can done by a single access point or by all access points

(WiSM-slot8-2) >config ap image swap all

(WiSM-slot8-2) >show ap image all      

Total number of APs.............................. 2

Number of APs
Initiated............................................ 0
Predownloading.................................. 0
Completed predownloading.................. 2
Not Supported.................................... 0
Failed to Predownload.......................... 0

AP Name            Primary Image  Backup Image   Status          Version        Next Retry Time  Retry

------------------ -------------- -------------- --------------- -------------- ---------------- ------------

TEST1                        7.0.98.0            6.0.196.159    Complete        7.0.98.0       NA               NA        
TEST2                        7.0.98.0            6.0.196.159    Complete        7.0.98.0       NA               NA        

Controller- Swapping the image on the controller

(WiSM-slot8-2) >config boot primary (backup)

(WiSM-slot8-2) >show boot          

Primary Boot Image............................... Code 7.0.98.0 (active)
Backup Boot Image................................ Code 6.0.196.159

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

Stephen Rodriguez
Cisco Employee
Cisco Employee

you should also be able to issue the command

show boot

to see what the primary and backup image on the WLC is.

What file did you load to the WLC?  If it had the -ER at the end, then it is only the ER/bootloader update.

The file should read AIR-WLC4400-K9-7_0_116_0.aes, to be the actual code for the WLC.

HTH,
Steve

----------------------------------------------------------------------------------------------------------

Please remember to rate helpful posts or to mark the quesiton as answered so that it can be found later.

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
Review Cisco Networking for a $25 gift card