Wireless

                   Hello,  I would like to install three antennas (2450S) on some AP1261 that i wold spread out 10 feet apart. I am not able to get the antenna on the C connector to transmit. I am not using 802.11N. This is for a warehouse where all ...

Hi,In ordering guide, 1522 are designed to withstand power surges on the AC power cord up to 4 kV as per EN61000-4-5 Level 4 & lightning arrestors are not required.What does it means? I've install the AP outdoor & using ant58g10ssa antenna. I'm afrai...

Hello  We have had a report running which provides a detailed log of our wireless users on a daily basis in order to maintain a history of use. It ran well on our WCS system but is not running well on our NCS.We are seeing instances where the reports...

Hi all,anyone can help me for this log ?Translatiuokng "CISCO-CAPWAP-CONTROLLER"...domain server (255.255.255.255)  o ooi po iopo*Mar  1 00:00:57.527: %CAPWAP-5-DHCP_OPTION_43: Controller address 172.16.250.252 obtained through DHCP*Mar  1 00:00:57.5...

Can i block roamers from accessing an APN (Access point) ? What will be the required configuration on ggsn.

Hi all,I'm designing a WLAN to support voice for Cisco Jabber on iphones/android and 7925 wireless phones and I'm unsure if to use central or local switching. Our WLCs are installed in our data centres and there is an average of 20ms from the WLC to ...

All,I am now managing an environment that includes a dozen or so small sites that are running isolated APs that for cost reasons have been left autonomous.  Most of the devices that connect to the APs are non-domain managed and the wireless is intend...

All,I have an integrated 881W with a built in 801 access point.  I'm interested in increasing the range of my AP.  I'm interested in considering any configuration changes while still maintaining support for N.  I've included a copy of my running conf...

i'm having some trouble pushing CLI templates to controllers in my lab.  i get an invalid credentials error but it is random.  sometimes i can push the template fine but 30 seconds later if i push the same template it will fail with error.  several m...

  Rogue device detection                I am getting these alerts Message: AP 'xxx' is being contained. This is due to rogue device spoofing or targeting AP 'xxx' BSSID on '802.11b/g' radio. - Controller The controllers are wism with 7.0.235.0 code a...

Here is what I am attempting to do. 1.  I have a 1042N AP cofigured as a Workgroup-Bridge attaching to a Lightweight Access Point.2.  LWAPP AP is on a 5508 series Controller.3.  I have MAC Authentication configured through an Ciso ACS box running 5.2...

    Hi  We have a WAP 200 wireless G access point.  It worked perfect before.  About two weeks agao,  we didn't change anything, it began to send empty alarm email every 10 minutes.  We upgraded the software to newest version,   restarted it several ...

I have an Aironet 1240AG.  I resides inside a building with its antenna placed on the outside of the building.  In direct line of site, I have a light pole to which I could attach another wireless access point to extend my wireless network.  This acc...