Upgrade firmware Cisco Access Point 6300H

[Xibachao1]

Hi all,

I have an access point Cisco 6300H but Mobility Express firmware.

How i can upgrade it to Lightweight version through USB port?

Thank all.

[Enes Simnica]

hello @Xibachao1 To upgrade your Cisco 6300H AP from Mobility Express to Lightweight firmware via USB, download the lightweight firmware (for example: ap3g3-k9w8-tar.*) from Cisco’s support site, extract the .tar file, and copy it to a FAT32-formatted USB drive. Insert the USB into the AP and reboot—the AP should automatically detect and install the new firmware.

check this one: https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/107911-ios-upgrade.html looks like great info and ensure the firmware is compatible with your AP model before proceeding. hope it helps...

-Enes

[Xibachao1]

Hi @Enes Simnica ,

I have read the document but it's seem likes not mention about automatically detect and upgrade through USB

[Enes Simnica]

hey man, my bad.....

check these, and hope they help.........;

• (Upgrade Firmware on Wireless Access Point) https://www.cisco.com/c/en/us/support/docs/smb/wireless/cisco-small-business-100-series-wireless-access-points/smb5193-upgrade-firmware-on-wireless-access-point.html
• (Mobility Express to Lightweight Conversion): https://networksandrants.com/2019/11/17/convert-from-mobility-express-to-lightweight-ap-capwap/

[Xibachao1]

Hi @Enes Simnica ,

Following this matter, but i can not find any file .image in Cisco download.

It's always "Wrong image format for "source" command" or "Bad image type" showing in UBoot.

Here is all from file .tar from Cisco

[Enes Simnica]

hello G, If the .tar u downloaded only has info.ver and no .image, then my man, u are using the wrong file type. Thats why u-boot shows "Wrong image format" and "bad image type". U mmust get the Lightweight AP software image, not the Mobility express bundle.

So u need to go to Cisco Downloads for u AP model and look for the filename similar to ap1g6a-k9w8-tar.<version>.tar

then download it, and extract it with this tar -xvf ap1g6a-k9w8-tar.<version>.tar 

which means that U SHOULD SEE .IMAGE FILE, HTML FILES AND MANIFEST FILES. IF U ONLY SEE INFO.VER, IT MEANS THAT IS NOT THE CORRECT IMAGE FOR CONVERSION...

-Enes

[Xibachao1]

Hi @Enes Simnica ,

I have download correct file from Cisco Download but it no have .image file inside.

I tried to using file btldr.img or btldr_duplo_plus.img but still the same.

[Enes Simnica · Accepted solution]

hello @Xibachao1 try the latest version 17_15_4_18 ---- CHECK THE FILE.....

[Xibachao1]

Hello @Enes Simnica ,

Hope you have nice day. I have checked and still no have any file .img in the file at your attachment.