cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
525
Views
0
Helpful
1
Replies

Using Dynamic Interface for RADIUS and WCS

steven.vandyk
Beginner
Beginner

Hello

I have a simple wireless setup:

WLC 2500 with 20 APs.

Mgmt vlan 1 - 10.100.0.X

Client vlan 20 - 10.20.0.X

Production vlan 10 - 10.0.0.X

Problem: WCS and RADIUS server are in VLAN 10.

Even with MGMT via wireless and MGMT via dynamic interfaces options enabled, the WLC refuses to communicate with the WCS and RADIUS.

Any way to solve this?

1 Reply 1

Stephen Rodriguez
Cisco Employee
Cisco Employee

That should work, provided that you used the dynamic interface when you joined the AAA and WCS and not the management interface.

That being said, this does go against the best practices for WLC deployments.  IMHO, I would remove the 'production' interface and put my wireless clients on another VLAN.

HTH,

Steve

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers