Wireless config analyzer error

[Janne K.]

I was trying to run my config through the Wireless Config Analyzer

but I'm getting this error: "Error: 479 Task OOM. Try again later."

I tried again later but still the same.

[marce1000 · Accepted solution]

 - Presuming you took the output from a 9800 controller (nor aireos) ; remember that Wireless Config Analyzer
   needs the output from show tech wireless not a simple show tech-support  neither show tech ; if the problem remains
   you could send your output to wireless-analyzer@cisco.com
   and ask for an explanation , or you may send it to me in a private message and I will have a look at it,

  M.

[Janne K.]

Ill try to contact cisco then, thanks.

[marce1000]

 @Janne K. - It looks like  OOM stands for Out of Memory ; so some  task suffered from that
                     The problem is either transient (temporarily) or not due to some bug (e.g.)
                      Using the mentioned contact from Cisco is a good idea ; remember to use
                      the correct outputs as I explained,

 M.

[Janne K.]

I contacted the email, and they came to the same conclusion. It works fine with the desktop version though.

[daxm]

How/where can I get the desktop version?  Googling just gives me the online one.

[marce1000]

  - @daxm    FYI :  https://pubhub.devnetcloud.com/media/wireless-troubleshooting-tools/docs/wcae-gui/releases/wcae-win-v10b.zip

  M.