09-09-2017 10:49 AM - edited 07-05-2021 07:37 AM
The Main Dashboard, Introduced in WLC Release 8.1 . Can be very helpful; even used for reports better than the ones in Prime Infrastructure BUT .......
Where is the definition of the values, intervals, and sampling ????
Network Summary
--- TOP WLANs -- USAGE ( What is the interval last 3 , 6, 12 , 24 hours ???? )
--- Applications BY USAGE ( What is the interval last 3 , 6, 12 , 24 hours ???? )
-- Throughput (how is it calculated ???? )
Clients
-- USAGE (volume) ( What is the interval last 3 , 6, 12 , 24 hours ???? )
AP Performance
-- CLIENT LOAD -- TOP APs ???
Client Performance
-- Client Failure Reasons (Since when ?????)
Can anyone provide this answers , or a Reference Document ?
09-09-2017 04:24 PM
I do not think you have flexibility to do that sort of time based view from WLC. It is real time snapshot.
Pls check below video to learn more about those dashboards
HTH
Rasika
*** Pls rate all useful responses ***
09-10-2017 03:40 AM
My question is not having that flexibility sorry
I want to know the data of the Volumes to what correspond. It has no sense to report MBytes or Gigabytes Volumes (Traffic , applications) if wr don't know the interval for that volume.
I think it must be documented. If not it has not any utility at all
Don't you agree ?
09-10-2017 06:23 AM
09-10-2017 07:16 AM
How do you know that? is there any document about details for Monitoring dashboard?
Do you know if the start time for the counter can be reset?
If not I think these counters are useless. most of the controllers I work with are up for months if not years .....
05-07-2019 01:51 AM
What options does one have to have the data from Monitoring Dashboard displayed through CLI?
05-07-2019 03:57 AM
What is the data you are expecting from the monitoring page ?
Hope below commands will help you.
05-07-2019 05:32 AM
Hi Sathiyanarayanan Ravindran, thank your for the rapid reply!
Vi are familiar with show avc statistics top-apps upstream/downstream which satisfies our need for top applications.
We would however like to pull data from the CLIENTS view in NETWORK SUMMARY
- Client Identity
- Device Type
- Usage
- Throughput
Pulling data via Excel unfortunately doesn't fit our needs.
05-07-2019 06:36 AM
No commands to get all the client with Single command. If you use the command show client detail <MAC Address> and show client stats <MAC Address> you can get the client details.
Do you have Cisco Prime installed on your environment? If so you can get the details through that.
05-09-2019 04:37 AM
Currently no prime in our productive environment.
Thank you however for your time.
05-09-2019 05:14 AM
09-09-2017 05:17 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide