WLC 7.2 - Custom WebAuth using waep Template w/ HTTP Only

[Jacob-Harris]

We are trying to get the waep template (default no changes) from the Cisco WebAuth bundle to work on a 5508 controller.

We've setup the controller to use the custom login.tar that comes with the waep template folder in the bundle.

We setup the WLAN to work off the global template and we used the config network web-auth secureweb disable command to allow only http rather than https (which is supposed to work in 7.2 code)

When we test with the custom bundle, we get no answer from the controller, just a url of

http://1.1.1.1/fs/customwebauth/login.html?switch_url=http://1.1.1.1/login.html&ap_mac=c3:12:30:01:a4:d0&client_mac=01:21:ca:b3:13:12&wlan=Guest&redirect=www.google.com/

If we turn custom off, and use internal everything works...

Just to be clear.. we aren't looking for authentication (user and pass) we are trying to do the enter your email and click accept to the aup method.

Thanks for any help!

[Scott Fella]

So did you just take the tar file and uploaded it or did you make a change to the HTML? You do have your WLAN setting as passthrough with email?

Thanks,

Scott Fella

Sent from my iPhone

[Jacob-Harris]

No changes to the tar file that comes as part of the bundle..

Downloaded the bundle,  unziped all folders locally.. then uploaded the login.tar from the waep folder right to the controller.

Changed webauth to use custom, and applied.

Tested multliple times with the same results.

[Scott Fella]

Could be something wrong with that HTML. I have had to make changes to some, but don't remember which one. Upload another tar to test. If that one works, then you might have to make changes to the other HTML to get it to work.

Thanks,

Scott Fella

Sent from my iPhone

[Jacob-Harris]

Will do!  Any suggestion which one to try?

[Scott Fella]

I don't know off hand. Just pick one that has username and password entry.

Thanks,

Scott Fella

Sent from my iPhone