03-04-2002 12:38 PM - edited 07-04-2021 11:00 PM
I'm trying to figure out which devices can associate with a workgroup bridge? Any help would be appreciated.
03-07-2002 09:19 AM
http://www.cisco.com/univercd/cc/td/doc/pcat/350wgbr.htm#BABJAHJJ
The above link should have the information you need. I hope this helps.
03-07-2002 12:53 PM
You can use it to networking with printers more advanced, you can use as the way you use a bridge but use it for less users (8 max.)
03-08-2002 10:33 AM
I'm not sure if this is your question, but the bridge can only associate with an Access Point and not other wireless clients.
It is intended to network printers or other wired devices in locations where you don't want to or can't drop cable. This way you can heat up small remote locations within the range of the AP without having to run cable there or getting a frame relay circuit (using a dish, range is up to 25 miles).
Cheers,
Perry.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide