关于使用超级终端XMODEM 无法传送文件至CISCO 2960

[00unhdt0kOEWvVSba5d6]

在配置完CISCO2960 交换机之后，使用#copy xmodem:  system:running-config 后，提示  %error opening xmodem

在传送文件时，也是提示远程系统没有响应。请问是哪里的问题？哪里设置不对？

[ilay]

没有超级终端，用的secureCRT测试ok

TEST1#copy xmodem: system:running-config
Destination filename [running-config]?
Begin the Xmodem or Xmodem-1K transfer now...
CCCCCC
Starting xmodem transfer. Press Ctrl+C to cancel.
Transferring sdn1_jl23-confg...
100% 7 KB 836 bytes/sec 00:00:09 0 Errors

Apr 27 12:30:35.901 CST: %SYS-6-CLOCKUPDATE: System clock has been updated from 12:30:35 CST Tue Apr 27 2021 to 12:30:35 CST Tue Apr 27 2021, configured from console by admin on console.
7552 bytes copied in 22.943 secs (329 bytes/sec)
TEST1#
Apr 27 12:30:35.943 CST: % Multiple self signed certificates in config
certificate for trust point TP-self-signed-4214836864 ignored

可以尝试换个软件试试，或者用tftp传吧，直接先传到flash里面，然后 copy flash:xxx.txt system:running-config 就行了。

xmodem这玩意儿传输速率太慢了

[YilinChen]

通常用FTP或TFTP，或者SCP(SecureSSH)，这三种方式来传输

[Rockyw]

楼主可以参考一下下面的帖子

switch: CCCCCCCCCCxmodem:: I/O error

https://community.cisco.com/t5/switching/switch-ccccccccccxmodem-i-o-error/td-p/2573884