Cisco ACI - Multi POD

[saurav.khanna]

I have a question; in my setup I have a external router connecting to IPN which is pushing a default route in IPN's Global Routing table via BGP ipv4 address-family.

I would like to get that published in ACI as well so that any traffic which has to head out to internet should be forwarded to IPN and then out. SO, basically instead of configuring an L3 -Out from a leaf I would like to configure an L3-Out from a spine. Is that possible??

[ranraju]

What you are looking for can be achieved through Golf - Please refer to this following link for more information - https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/2-x/L3_config/b_Cisco_APIC_Layer_3_Configuration_Guide/b_Cisco_APIC_Layer_3_Configuration_Guide_chapter_010010.html

I hope that helps.

[saurav.khanna]

Thanks for the response, in my setup I already have a Golf router. The IPN routers that I have are acting as Golf as well.

So, I am not sure how to get a default route there..

Saurav

[inderdeeps]

check out the ACI Multi pod deployment

http://www.routexp.com/2017/11/introduction-to-cisco-aci-stretched.html