cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
6470
Views
21
Helpful
4
Replies

Interface range in ACI

Hello.
Is there a command / way to use an "interface range" in ACI to shutdown a range of end devices Leaf interfaces or no shutdown interfaces?

2 Accepted Solutions

Accepted Solutions

tawa-ndafa
Level 1
Level 1

apic-01# conf t
apic-01(config)# leaf 101-102
apic-01(config-leaf)# interface ethernet 1/1-48
apic-01(config-leaf-if)# shutdown

View solution in original post

Vishalhathi
Level 1
Level 1

Hello Fernando,

you can do it with APIC.

apic1# configure
apic1(config)# leaf 101
apic1(config-leaf)# interface ethernet 1/2-5
apic1(config-leaf)# shutdown.

 Regards,

Vishal

View solution in original post

4 Replies 4

Sergiu.Daniluk
VIP Alumni
VIP Alumni

HI @Fernando Hernández 

You can access the NXOS vsh to shutdown a range of interfaces, however, the only drawback of this method is that it will not be reflected in APIC GUI:

Leaf1201# vsh
Leaf1201# configure
Leaf1201(config)# interface e1/3-4
Leaf1201(config-if-range)# where
  conf; interface Ethernet1/3-4      root@Leaf1201
Leaf1201(config-if-range)# shutdown

Stay safe,

Sergiu

Nice it worked !

tawa-ndafa
Level 1
Level 1

apic-01# conf t
apic-01(config)# leaf 101-102
apic-01(config-leaf)# interface ethernet 1/1-48
apic-01(config-leaf-if)# shutdown

Vishalhathi
Level 1
Level 1

Hello Fernando,

you can do it with APIC.

apic1# configure
apic1(config)# leaf 101
apic1(config-leaf)# interface ethernet 1/2-5
apic1(config-leaf)# shutdown.

 Regards,

Vishal

Review Cisco Networking for a $25 gift card

Save 25% on Day-2 Operations Add-On License