ACE 4710 config

[gavin han]

Hi,

I'm new to ACE and trying to configure AAA for it.

ACE's 4 eth interfaces are not showing up when I do "sh ip int b". please advise why?

can we configure tacacs for ACE for whole user group instead of doing it per user?

[Gilles Dufour]

Does it show interface for the Admin user ?

Does it show them if you do not have AAA configured ?

What version do you have ?

Gilles

[gavin han]

===

Does it show interface for the Admin user ? - no it doesnt.

Does it show them if you do not have AAA configured ? - no it doesn't show, i dont' have aaa configured right now.

What version do you have ? - I'm using "c4710ace-mz.A3_2_0.bin"

===

what could be the issue? do we need to have license to get it show up in "sh ip int b"?

[Gilles Dufour]

The command is accepted but it just does not display anything - right ?

In this case this is not a license problem or AAA issue.

Are you in a context ?

The physical interfaces are only visible in Admin context.

And if you did not assign any vlan to your context, you will not see anything with the interface commands.

Gilles.