ACE30 - Accessing the ACE Applicance Device Manager

[sgonsalv]

Hi...

I've got basic connectivty to our ACE30 module and when I try connecting to the management IP address (attached to the Admin context), I see a very basic GUI which only lists the CSM to ACE config conversion tool.  I don't see a GUI as detailed in the document:

http://www.cisco.com/en/US/docs/app_ntwk_services/data_center_app_services/ace_appliances/vA1_7_/configuration/device_manager/guide/UG_over.html#wp1072950

How do I get the ACE Applicance Device Manager GUI working so that I can then configure real servers, serverfarms etc rather than via the GUI?

Having read through copious amount of documentation I can't seem to find a refrence that would help here.  This should be a fairly straight forward exercise - do I need to install some other software to get the full fledged GUI working?

thanks

Sheldon

[agvelegol · Accepted solution]

Only the ACE 4710 appliances have the GUI.   If you are looking for a GUI for the ACE30 module you will need to use Cisco Application Network Manager (ANM)   It will provide the GUI for the ACE30 to be able to configure it.   As you have seen, only the conversion tool is available on the module.

[sgonsalv]

Thanks for the response.  I'll look at getting the ANM.

Cheers

Sheldon