Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a vpn tunnel with the following setup:crypto map remotevpn 11 set peer <peer1> <peer2>tunnel-group <peer1> type ipsec-l2ltunnel-group <peer1> ipsec-attributes pre-shared-key abctunnel-group <peer2> type ipsec-l2ltunnel-group <peer2> ipsec-at...
I just setup a new lan controller and registered some AP's successfully, however the AP's are not broading the SSID's and I noticed that their operational state is down.Why is it down and I do I bring them back up?From the controller I can see the AP...
I have a very simple request on 8.6 code, I need to translate a public ip address to a private on a given port, I have the following :object network obj-TEST host 192.168.10.10!object network obj-TEST nat (inside,outside) static 88.88.88.88!access-li...
HI,I have a single core switch 3750 connected to 2 asa's each having its own dedicated Internet circuit, so the asa's are not in failover mode.I have a dedicate demarc vlan to each asa and running eigrp on the 2 demarc interfaces + the asa with one p...
Anyone knows what that means, we are getting a lot of falformed and checksum errors and this is what the switch logs say:Sep 15 23:46:36.096: TPLUS(000011A6)/0/READ: Would block while reading*Sep 15 23:46:36.222: TPLUS(000011A6)/0/READ: socket event ...
(Cisco Controller) >show ap summaryNumber of APs.................................... 5Global AP User Name.............................. Not ConfiguredGlobal AP Dot1x User Name........................ Not ConfiguredAP Name Slots AP Model ...
