Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Would it be possible to configure ACE4710 to accept tcp connection on port 8900 and redirect them to 2 different rserver + url + different port number? Example:VIP:www.abc.com:9999/test1 #redirect to (a) or (d)www.abc.com:9999/test2 #redirect ...
In our other load-balancing environments the load-balancer-cookie contains the encrypted (real) servername or ip-address.We think it's the same on the cisco, for that reason it's in theory not possible, that there are two 'green'-cookies with differe...
Hi All,We have a two ACE module running in a redentant setup in CAT-6500.The software version is Version A2(1.6a) [build 3.0(0)A2(1.6a) It has started giving many issues lately, promtping us to think of asoftware upgrade. Please advice, which versi...
Hi Need a feddback about this issue I have two CSS 11503 with load balancing active on # 03 This machine register an high charge of connection and server Front end are very slow to log in ( the ICMP reply works ) Did someone can see something wrong...
Hi,i am receiving a wafs_roles_change major alarm on WAVE 574 device as shown below. In fact i had disabled n enabled cifs accelerator once and since then i am receving this alarm. However now cifs accelerator shows enabled and running as mentioned b...
I have run into an odd situation where the ACE sends a TCP reset for the public leg of a TCP session prematurely. The setup looks something like this.Internet-->FWSM(context)-->ACE-->rserversclient upload NAT exemption routed ...
Hi Guys,Have an odd issue as explained below:I have a URL rewrite policy as configured below:! policy url-rewrite SAKAISTGREWRITE url sakai-stg.its.monash.edu.au* !Now...this policy isn't attached to a service at all:drc1-ssl#sh ssl-proxy policy url...
Normally we see services transtion from up/down and vice versa on an almost daily basis, although we see these in the trap/sys log we do not ticket on these.However, this morning we recieved an incident ticket based on the following event: Basically ...
We're running a redundant pair of ACE SM's in bridge mode and were requested by the customer to access the back-end servers via ssh. We currently allow only IP and ICMP in our access-list that we apply to the client side and server side interfaces. C...
We have an inline module with the four gigabit ethernet ports installed in a WAE-512 appliance. We are currently using only two of the ports for inline interception/acceleration. Is it possible to use the second pair of ports for an additional inline...
We have some webserver behind our ACE that use SSL certificates that are issued by an internal CA.Do I need to do anything special in order to probe HTTPS? Does the ACE need the internal CA to be trusted?Thanks.Jason
Hello All,ISO 8073 COTP Connection-oriented Transport Protocol.I want to modify the Destination TSAP. Can it be done with ACE SM ?I,m running A2 2.4RegardsMats
The documentation for configuring Tacacs authentication at this link (http://www.cisco.com/en/US/docs/app_ntwk_services/data_center_app_services/application_networking_manager/4.2/user/guide/UG_admin.html#wp1267519) states the following:Note For the...
HI everyone,can you please send me the product part numbers for the below item:CISCO EQUIPMENTQuantityIP Service gateway Base license 1K sessions150Per subsriber Traffic policing shaping 1K session150Application detection and control (dynamic content...
