Application Networking

Hi!I have a site that I'm load balancing using an ACE 4710.  The FQDN of this site is mysite.mydomain.net.My users only connect via SSL.  However, while most use the FQDN of https://mysite.mydomain.net/, some insist on using https://mysite/.  Both of...

I'm working on a design that requires traffic be sent to a different context in the same ACE. The question I have is can this be done when both reside on the same VLAN. Would the traffic in this case be handled at layer 2 instead of layer 7. Would I ...

I am New to ACe Loadbalancers. We have just installed the ANM4.1 and we are trying to import both appliances into the ANM4.1. Is there somthing I sould be aware off before I do the Install.? The question is when O do the Import does the ANM will have...

Can anybody let me know the steps / Commands to terminate SSL certifcate and key for ACE management purpose. It will help me to access the ACE box through explorer using https.

LMS discovered all WAAS we have but unable archive or collect inventory. my question is is that because I need device context on LMS or WAAS not able to manage on LMS 3.2.Thanks in Advance for any insight .

I have a remote WAAS site where a SM-SRE-900 module is plugged in a 2945 router. Everything is fine except the module can't sync its time to the NTP server. Its NTP was configured right and it can reach the NTP server with no problem. There's no auth...

Hi All,Usually, I configure real server and their default gateway is inside a vlan in the own ACE module.I configure the real servers, serverfarms and the probes and works fine.Now I have to configure a load balance where the real servers are outside...

Hi all,i have a SLB Application Processor Complex module on my Cisco 6504 which basically does some load balancing work. I am pretty new to this device but the configurations and setup looks somewhat similar to the Cisco ACE but i only have some expe...