Hello, I would like to know if it is possible to set the HttpOnly flag on cookies inserted by ACE module. I couldn't find any thing as such in the configuration guide. Other load balancers do support this functionality. Thanks.
HelloI have configured pbr on 2821. And the next hop on route map is pointing another subnet and not same as the router interface to which route map is applied. should this type of configuration work. ios version is 12.4I dont see anything on debug i...
Hello, I would like to know if the following is possible with Cisco ACE module A2(2.0)1. With predictor least-loaded based on SNMP, can I define an independent SNMP probe against each rserver within a serverfarm. For e.g. I need to poll the SNMP OID ...
Hello, 1) In an MPLS cloud, if the primary and secondary links are configured without the metric, does the BGP AS number act as a metric value2) What is the influence of AS number on AS-path prepend (in absence of metric)Thanks.
Hello,Please find attached the site to site connectivity diagram over MPLS L3.If the HSRP is configured on both sites at the router inside interface, how can the routers be configured in a way that if an active link on the other or local site goes do...
Thanks. The network setup is two routers (on different networks) are directly connected to the same firewall. The return path/route for the source WAN subnet defined on the FWSM is pointing to router B. However, for some destination networks I would ...
Hello Daniel, Thanks for the response. To use the predictor least-loaded, using SNMP probe with predictor seems to be mandatory due to the syntax i.e. predictor least-loaded probe snmpSince predictor is defined globally for serverfarm, will the rserv...
Hi Milan,Could you please provide a configuration example for the following"you can configure one of the routers on the site as primary - advertising the site prefixes to the backbone with better BGP attributes (lower MED)"Thanks.
Hello,- show run natnat (inside-ASA) 0 access-list inside-ASA_nat0_outboundnat (inside-ASA) 1 0.0.0.0 0.0.0.0- show run globalglobal (outside) 1 interface- show run staticstatic (inside-ASA,outside) tcp 80.224.20.10 https 10.1.2.50 https netmask 255....
Hi Frederico,Is the below configuration part of the crypto map ACLVPN Configuration:Site A:access-list vpn permit ip 10.1.1.0 255.255.255.0 10.1.2.0 255.255.255.0Site B:access-list vpn permit ip 10.1.2.0 255.255.255.0 10.1.1.0 255.255.255.0I am exper...
