Application Networking

I will be connecting a Data Center WAE-7341 to a distribution layer made up of two 6509s. The 6509s currently have a /30 L3 connection between the two of them on routed ports. I plan on changing that to a /29 SVI connection (changing the ports to swi...

Hi Guys,I am tryign to deploy a solution where by i have 5 servers sat behind the ACE in a routed fashion. There are static nats to these servers for management. 3 of the servers are standard web farm.Now these 3 servers need to speak to a VIP setup ...

In the parameters to be set for stickyness based on IP, there is a mask to be configured. Can someone explain the behaviour of changing the length of this mask, say 255.255.255.0 versus 255.255.255.128 or any other permutation.Also, I would like to ...

Good day, I have a general question on the SSL module. Currently we have a pair of CSS's handeling our external site web sites. We are starting to run out of external IP addresses, If we installed the SSL module and terminated the Certificates on the...

Hi,I would like to know why ACE doesn't export SSL key in unencryped format?Thanks in advance.RegardsSum

Hi, I have the following inquiry, there is 2 CSS loadbalancers running as master and backup. I have configured a reporter on the master LB, should i need to configure also the reporter on the backup CSS ?thank you.Jean

Wanted to confirm if the slot and sublot outputs in the show group command is the same as the Interface numbers in a CSS. Please see attached word document for the two questions.

Hello,Is it possible to rewrite the redirect URL destination with the ACE? I have real servers sending clients a redirect URL that I would like to rewrite.Thanks!

Hi,When i configure VS with ANM the ACE gets crashed/reboot automatically. And also i see the ANM geting timedout after 10 minutes and the message i get is 'failed to deploy". Can someone assist me on this. Thanks in advance.

I'll be using WCCP to redirect. I'm running 12.4(20)T right now - is that good enough for the WCCP functions?

There are two separate Cat6513 chassis each contain a CSM.We configured as active/standby.According to my understand, the traffic should be gone through only active one. But when I tried to "sh module contentSwitchingModule 5 conn" on the standby one...

Hi experts, Pls help me...i need server laod balance on ACE4710 with routed model sample configuration or configuration guide....thanks in advance....