Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is that possible to run MPLS over GETVPN? We have a customer having MPLS connectivity from a service provider and they want to run their own MPLS over the service provider MPLS. I found the implementation guide to run MPLS over DMVPN but not sure eit...
G'day Guys,Scenario is that VSS is established between two 6500 with single SUP in each chassis but each chassis located in different DC and VSL is established via 10Gig link. My question is that for the following dual active detection mechanism, can...
G'day Gurus,I have created a profile for Network Access Mnaager using Standalone version of Profile editior. May I know the steps to deploy on end node?Cheers,Ahmed.
G'day Guys,I am trying to install the certificate on Cisco Wirless Control System and using the steps defined in the given below URL:http://www.cisco.com/en/US/docs/wireless/wcs/7.0MR1/configuration/guide/hard.html#wp1042471I am getting error in step...
Hi Gents,I have following questions Dual SUP vs Quad SUP:1. With dual SUP VSS (one SUP in each catalyst), if one SUP died the other SUP will take over the control plane, does the data plane would be active on both Catalyst in this scenario? 2. Do you...
Thanks Jon,I am checking counts on "show route-map PBR_WSA" and could not found any hit.There are number of SVIs and the requirement is one host behind an SVI use routing table (except default route) and a customize L3 interface for all other traffic...
Thanks Jon.I have tried both options set ip default next-hop and set ip next-hop but it does not work.Please note that I want packet route using routing table except default route and then the PBR.Any idea how to achieve it.
Hi,Thanks Lei for your response.It means we can run GETVPN among PE and P routers without any problem. We can establish a separate point-to-point tunnel between CE and PE. Do you have specific document showing configuration of MPLS on PE and P router...
