Application Networking

I have a brand new WAE512 with no inline card plugged in. During bootup, it says "operating system not found". I then tried a 4.0.9 Recovery CD. At the Installer Menu, I selected "install image from cdrom". But the message came up as "no Flash detect...

I have 3 VIP's setup on an ACE 4710 Appliance and they are all working correctly. 2 of them I can ping and get ICMP replies back the 3rd (also the busiest) I dont get ICMP replies back. The config is identical between them all as far as adding in the...

HiSince WCCP has been enabled on the 3750's there has never been the WCCP option to "ip wccp redirect exclude in" from the WAAS unit to stop Loops. Is there any way round this or is the only option to configure PBR on the 3750.ThanksIan

Hi, I am unable to authenticate via Radius, the ACE server does not even see an attempt by the module. The following is my config in the Admin context:radius-server retransmit 3radius-server host 10.9.48.135 key 7 "*****" auth-port 1645 authenticatio...

I have had a customer raise an issue with me. Unfortunately I am not too hot on the CSM.Switch Type - Cisco WS-C6513IOS VSN - 12.2(18)SXF4CSM Module detailsCard Type - SLB Application Processor ModuleModel - WS-X6066-SLB-APCHardware VSN - 1.8Software...

Hi,I am asking me if it is possible to load sharing traffic itend to a vip with two serverfarm.I would like to have two serverfarm active no active/backup for my vip. Thanks for help.Regards.

Hi.I have acns 5.5. When I download the large file size, it is loaded for a long time. I can change options on acns what would file more than 100MB not caching?

<br />I have configured the VIPs on GSS and the it is working fine. But I don't see the hits/counts going up. Any thing is required to enable the counts.

I have configured Windows DNS server to service incoming internet traffic and set the DNS settings on the machine to local IP. The Windows DNS forwards requests to Cisco GSS for certain A records.Now when I ping any internet domain/hostname from a PC...

Hi, I was adding logging and snmp to my ACE modules this weekend. I first made the changes to the primary ACE module and did a wr mem; I then went to my secondary module and noticed that the modules did not sync. After some troubleshooting; I decided...

We have two CSS devices set up as DNS host for our failover scenario.This works well, but I had a question about the TTL in the config for the DNS a-record.Currently our records are set as follows:dns-record a http://www.mycompany.com 1.2.3.123 50 si...