Application Networking

Hi !I am trying to setup a LB condition based on SOURCE-ADDRESSES.I did the following:1) created class-map:- class-map match-any SRC_LB 2 match source-address xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx- defined policy-mappolicy-map type loadbalance first-match ...

hi all,it's possible to mantain 2 separate application flows but both contain SAME unique cookie information?i need to be stuck to same real server.tksAghi

Hi experts. We are using an ACE 4710 and we decided to put some probes on our server farm for health monitoring. Those probes are set to monitor the health on each 60 seconds in order for us not to full the IIS logs. But if a real problem occurs, I w...

Is there a way to schedule a reboot task on a CSS switch? This would be a weekly reboot.

hello,we have 2x6509 with ace and fwsm each. ace is acting as a bridge between fwsm and servers. fwsm is the gateway for all severs.fwsm is having 2 context (fwsm A and fwsm B) with fwsm context A active of 6509A and other fwsm context B on 6509B. si...

Hi,I have a question on wccp support on 1700 router running ipbase image. once wccp ver 2 and service 61 and 62 are enabled on the router, it forms a service group with the engine and it sees the wae but once redirection 61 on the lan interface and 6...

HelloWith help of inayathulla1, I created a policy in the SSL module that change the HTTP server's redirection to the HTTPS. It works fine but, unfortunately when the packet comes to the browser it seems that SSLM module makes some modification in th...

Hello All, I have an issue, where the MAC address of one of the interfaces on the CSS no longer shows up on the L2 switch's mac address table. The interfaces are bridged vlan's.Because the switch does not see the mac address, connecting to the VIP's ...

i configure the the active ace to track gateway using icmp probe when it can't ping the gateway it decrease the priority from 120 to 70,so the standby ACE take over but when the ping back to the first ACE it doen't increase the priority from 70 to 12...

Hello all i tried upgrading the code on the CSS from version 7.20.0.03 to version 7.40.2.02. Before the upgrade I archived the scripts file called ap-kal-tcp-ports that I use for the keepalives.After the software upgrade I restored the script file bu...

Hi,At one of my customers they are using a CSM and we saw that we have a lot of connections in the state CLOSING .According to the docs it means that it is waiting for the FIN ACK .I haven 't done any sniffing to check if the fin ack arrives or not ....

Hello,I want to order ACE-4710-BAS-2PAK bundle (2 Units of ACE 4710 Hardware-1Gbps-1K SSL-100MbpsComp-5VC- 5) and then separate two units of this bundle.I couldn't get any information about separation possibility, therefore “some how” i need to e...