Application Networking

Is it possible to use multiple WAE-302 network modules in a single router for a medium sized site, instead of using a single 502?

Hi ,What is the best IOS for Cisco ACE Appliance 4710 .I have a ver which has lot of caveatsUKPRGMFWPRACEO1/Admin# sh verCisco Application Control Software (ACSW)TAC support: http://www.cisco.com/tacCopyright (c) 1985-2007 by Cisco Systems, Inc. All ...

I am using the CiscoView Device Manager and trying to create a CSR to send to Verisign. The wizard is called Certificate Trustpoint setup. On step 4 it asks to specify the CA certificate PEM file from the client machine or copy and paste the PEM ce...

Running 4.1.1a (not going to 4.1.1c anytime soon) We would like to "confirm" that WAAS or rather the appliances are working as designed. We have several 7326 deployed...and although they have alerts they do not notify on a file transfer is slower t...

I need to craft a exclusion for traffic that would normally be optimized through WAAS. How should I go about this; and suggestions would be great.

I have two web servers (PISWEBP01 & PISWEBP02) with the following configuration on 11501. I take the default load balancing scheme (round-robin) and expect the connection will be distributed to the two server evenly.But, the result is PISWEBP02 recei...

Hello,has anybody a configuration example or some hints for configuring two WAE and one CM connected to the ASA inside interface. The ASAs have an IPSec VPN Tunnel connection to their outside interfaces. Is it possible to configure promiscuous mode o...

We installed WAAS last year. We see improvements with file acceleration with Microsoft based files, but no improvement with AutoCAD files. It still remains slooooow. I have even setup a preposition job for AutoCAD 'content' and all of our projects. I...

We have rolled out the 512 wae's to the edge offices and a couple of the 7236 wae's to the core and running the 4.0.19 code level. We have centralized all the data on the core and allowing only cifs traffic for optimization/acceleration. What we have...

I have just noticed that the CPU utilization on my core WAE is averaging 96%,is this normal? If the CPU utilization report is to believed, then when I was running 4.0 the utilization was only 4% I have 19 remote sites with WAE 612 their average utili...