We have rolled out the 512 wae's to the edge offices and a couple of the 7236 wae's to the core and running the 4.0.19 code level. We have centralized all the data on the core and allowing only cifs traffic for optimization/acceleration. What we have...
I have just noticed that the CPU utilization on my core WAE is averaging 96%,is this normal? If the CPU utilization report is to believed, then when I was running 4.0 the utilization was only 4% I have 19 remote sites with WAE 612 their average utili...
Hi all,Now that I have upgraded to 4.1.1c I want to clear all historical data and start from scratch with the graphs/stats/reporting. Is there a way to do such a thing? Could not find anything in the docs other than "clear statistics all" which seems...
I was just wondering if anybody has had any luck improving the performance of the Powerbuilder app in a WAAS environment? We moved this app from the local server to the core and its performance has degraded substantially. Thanks..
I have WAE 500 , installed ACNS 5.3.3.8 on it , transferred it to a new location in the datacenter , then at power on i found the following output:IBM BIOS (C) Copyright IBM Corporation 2004Intel(R) Pentium(R) 4 CPU 1.86GHz512M System Memory Installe...
What I want to do:ACE B, which is in the STANDBY_HOT state should going to ACTIVE mode when ACE A, which is ACTIVE,goes down. ACE B, which is in ACTIVE mode now should stay ACTIVE even when ACE A comes backup.I made already several tests and saw, th...
hi, I have imported the SSL keys/Certs to standby ACE module and the FT group status is now showing HOT_STANDBY instead of COLD. However, I don't see key and cert under ssl-proxy service definition as well as the reference to ssl-proxy server in the ...
Hi allI am facing an issue with waas reporting, in the charts i have OTHER TRAFFIC with a high percentage (50% and sometimes more)What can i do to know which traffic is being categorized as OTHER TRAFFIC so i could create new policy for it
I have an environment where I will be using inline on the remote side and WCCP in the hub. We have a known issue for a set of servers when they are redirected via WCCP. We're using ACL's on the routers to deny WCCP redirection for these servers. N...
Hi All ,I want to know if it's possible to make a tunnel between 2WAEs with IP addresses instead of peering based on TCP header manipulation ?Thanks .Regards ,
We have alarms for power supply failure on 7371 box. We replaced the defective power supply . But unable to clear the alarms. How do we clear the alarms ? Our Central Manager still reports that, power supply is still dfective..
We have a CSS that appears to be rewriting the client source IP for HTTP requests with its own IP. This is an issue as we're unable to log the real IPs of the clients requesting HTTP data.The config is attached.Any assistance would be appreciated.
