Application Networking

Hi,I configured a CSS to balance the load depending on source IP address to suppport a application feature in the server. We have two firewalls and behind we have different users. We have also two servers behind the CSS.Firewalls perform NAT with a u...

CSM - Is it possible to have the vserver (VIP) IP in a different subnet range than the real IP addresses in the serverfarm that is bound to it? In other words, as an example a typical bridge configuration is like this: vlan 221 client ip address...

My csm currently is configured as the routing mode and bridge mode, resently I have a service requirement which I think the one arm mode should be the best resolution. Can anybody let me know if there will be any affect if I add the one arm mode to t...

Has anybody any experience with WAAS over Satellite network?Since latencies are above 550msec

Does anyone know how many TCP connections the 674 will support with various memory options? TIAmike

Hi,What happened when we have multiple match conditions created under the "Configure Match Conditions" section in the application classifier window page?Is this a OR or AND operation on all these match conditions created?

We have a CSS doing HTTP load balancing. There is no SSL termination done on this device. will the domain name change have any impact on the load balancer?thankssathappan

Is there a command which compares the configuration on the primary and secondary members of a CSS pair configured for ASR?In production I want to be certain that the two members of the redundant pair have complimentary configurations that will work i...

Hi - I'm designing the network topology for a multi tiered application using a 6509 with ACE and FWSM. Each tier will be in it's own VLAN and IP subnet and communications between tiers needs to be firewalled and in some cases loadbalanced. I propose ...

Hi,I would soon be carrying out my first WAAS POC on customer site.Would like to share in any experiences while doing the POC.Would like to share in any ideas as to know how to go about the POC and any pitfalls to watch out for.Thanks

Could I have a pointer to a typical network diagram to indicate the following Requirements.VLANs - all necessary VLANsSubnetsActive/Standby RedundancyServer load balancing without SSLServer load balancing with SSLSSL TerminationSSL InitiationFWSM VLA...

HelloIn my network we have a redundant pair of 6500 with CSM modules. After we changed a configuration on the active CSM and tried to synchronize the config with the standby module with the command hw-module csm slot standby config-sync, the standby ...

I noticed that under downloads on CCO, the top of the list is 8.10, further down is 8.20. Should I use WebNS 8.10? 8.10 and 8.20 have the same release dates. Any gotchas out there?