About olighec

olighec · 11-01-2012

All,We are currently running Callmanager 7.1(5) Business Edition on a MCS 7828 server. I want to make sure I know what to do in the event of a hardware failure in that server.We are already running nightly full backups to a remote SFTP server using ...

olighec · 01-30-2012

Hello all,Running CUCM 7.1.5 and currently have a Cisco 2811 with 3 PRI circuits as a MGCP gateway. We are bringing in a SIP trunk from our telecom provider for evaluation and I was wondering -- can I use that same router to terminate the SIP trunk ...

olighec · 05-12-2011

Hello all,I have a remote gateway with a single PRI that can receive calls just fine, but has never been able to place one successfully.The error I get is 0x80B2 - Requested facility not subscribedI have had a service call with the telco and after pl...

olighec · 07-30-2010

Hello all,Brought up a remote office this morning with a 2821 router/voice gateway. The PRI is up and running fine and is registered with remote Callmanager over MGCP. However, I am trying now to register the NM-HDA-4FXS in the same router, but can...

olighec · 04-19-2010

Hello all,I have an 1841 router that we've been using as our L2L VPN hub at our main office. All of our home office users have L2L IPSec VPNs that terminate on that router. Currently, they all have various broadband connections with static IP addre...

olighec · 11-02-2012

Rob,Good to hear!So, I've found that the Cisco MCS7828-H3 is essentially the same hardware as a HP DL320 G5p with a Cisco green bezel. I will be picking up a spare DL360 G5p and keeping it in our colocation facility offsite in case the MCS fails.Wha...

olighec · 11-02-2012

Allan,Thanks! So if I am reading correctly, as long as I have hardware that is on the compatibility list ready, I can install my licensed build of CUCM on the hardware, contact licensing to have my current license files replaced with the MAC address...

olighec · 01-30-2012

Chris,Thank you. That is exactly what I needed to know. I will look into adding the licensing as we have a large Cisco purchase coming up this month anyway (SMARTnet renewal time).Thanks,Chris

olighec · 05-13-2011

When I change the plan to anything other than National, ISDN, I get back 0x82E470 - Invalid information element contents from the remote switch.I switched the channel ordering which causes some D-channel jumping when calls are coming in and I am tryi...

olighec · 05-12-2011

Roman and Adrian,Unfortunately, I've had those boxes unchecked the whole time. We have never attempted to deliver calling name ID since the telco adds it on their end.

Member Since	‎01-11-2006 02:39 PM
Date Last Visited	‎01-31-2024 12:13 AM
Posts	174
Total Helpful Votes Received	10

User Statistics

User Activity

Replacing a failed CUCM Server

Can I terminate a SIP trunk on an existing MGCP gateway?

Cannot place calls outbound on PRI, inbound calls work fine

Registering NM-HDA-4FXS with CCM over MGCP

Can Dynamic crypto map coexist with static crypto map on one router?

Replacing a failed CUCM Server

Replacing a failed CUCM Server

Can I terminate a SIP trunk on an existing MGCP gateway?

Re: Cannot place calls outbound on PRI, inbound calls work fine

Re: Cannot place calls outbound on PRI, inbound calls work fine