Application Networking

We have a pair of CSM 4.1.6 in bridge mode and we have a VIP for passive ftp set. We are seeing consistent errors with FTP port 1985. We took several captures and notice that conns show ESTAB on CSM but the client sends the SYN receives the SYNACK th...

Hi,Can we integrate print services into Windows AD, so when a user wants to select a printer to install it can be be found in AD, rather then having to map the edge WAE from the desktop?Thanks,Vip

Hi,I wan to cofigure my CSS to advertise VIP addresses through ospf. Everything is fine untill I want to use SSL termination on these VIP addresses. This is because the contents for SSL terminations ares always in "Alive" state. They dont observe the...

I have dot1q enabled 7507 connecting frame relay branch to data centre.Core WAAS sits on a VLAN subinterface.As soon as I enable "ip wcccp redirect 61 in" on VLAN trunked interface, I am loosing connection to the branch.the config is here..interface ...

Hi,I ordered an extra disk for a 512 with a single disk installed. Is there a procedure for installing the new disk and getting the Raid 1 built or can I power the WAE down install the disk power it on and watch it build the Raid?Thanks,Mike

It is relatively simple question but I can't find the answer in documentation or forum. Is it possible to have 2 rservers, both in different IP segments (different IP networks) and still use it in one serverfarm? and loadbalance its traffic with comm...

Hi,I am facing a problem configuring FTP servers behind CSS 11501 and I would apreciate your help.The FTP service needs a GROUP, with the same VIP address as the CONTENT rule, configuration to work correctly. The problem is that I have already config...

i have a question in the positioning of the WAE device in integrating with our network (I will be using the InlineGroup not the WCCP). we have a 6513 for both HQ and Branch that serves as our router and LAN switch. My question is: If I will be integr...

Hi We have a MPLS network with numerous sites but all our apps run from a central location.Anyway we'd like to put a WAAS device on 1 of the remote sites to see if it improves the performance of the apps. If we do this dow we just need to get 1 WASS ...

Guys,I am encountering an issue accessing a server in https only when i get redirected to a .jsp page.I am doing natural https <=> http url transformation but when i am accessing the.jsp page i am gettin (on my client) the http url instead of the htt...

GreetingOne of application server behind my CSS11506 has problem with authentication using ldap. The ldap server is at outside of CSS (client side) and the application server is behind CSS, I configured as:service app-serv ip address 10.1.1.223 proto...

Hey again.I have been looking into the CSM return code checking feature as suggested by this forum. This is a little closer to what I am looking for but I have question about what happens when there is a failure.If a 500 code for HTTP is seen three t...