Application Networking

Hi,I have a problem with my CSS aca algorithm as shown from the following show load and show service summary:CSS1# sh service summary Service Name State Conn Weight Avg State ...

Dear,I want to buy a device has funtions same CE-560 (EoS). Please advise me the new deviceThanks,Danh

The white paper below notes that the CSS CAN operate in bridged mode but it is not recommended. Is it possible to load balance more than a single subnet while operating the CSS in bridged (single VLAN) mode? I would like to test how effective it is...

Hi,Is there anyone who have an idea of the maximum number of content rules we can configure on a CSS 11503?Thanks & RegardsWig

For failover purposes we might want to have multiple routable /24 subnets at the outside of the CSS (facing the Internet.) But I understand that if you put a secondary IP address on a circuit/VLAN associated with an interface - the CSS will not be a...

I have a problem with WCCP redirection on a 3750 switch. hardware and IOS versions are listed as supporting WCCPv2. WAE configured at a core site and at the remote site. "ip wccp 62 redirect in" configured on the interfaces at each end connected to...

Hello,I have a simple SLB configuration running in RP mode. If a client on the same network as the virtual IP tries to connect to the VIP, it fails. I'm guessing this is because the communication is done at layer 2 and the packet never gets sent to...

Hello,our customer has typical ACE configuration in routed mode with enabled direct access from client side to server side. ok. access to server port is enabled. when I try telnet to server_ip:service_port, I can see 'established' connection on the A...

I have been working on and testing a solution using WAEs to optimise a link between two sites both with WAEs. The TCP promiscuous mode service has been setup on both WAEs and WCCP appears to have successfully negotiated the connection etc to the WCC...

We have the following config setup using two interfaces:Client(.10.33) -- VLAN10 -- CSS -- VLAN10 -- Servers (.10.31, .10.32)We have source-nating set up for the Client. We are trying to set up content routing on an SSL flow, and hence need to use bo...

Well, I got the CSS working fine with terminating all inbound SSL connections to a backend server port 7777However 1 problem has come up. When I have the oracle admins trying to upload a file to the backend webserver via the proxy and their webpage u...

Hi Guys,One of our clients wants to setup an SSL connection on a non-standard SSL port i.e. 4444 to begin with. Here the sever handles the SSL encryption / deccryption) instead of the SSL module. I've found the following config to work well:serverfa...

I have a requirement to send traffic to another server on the private side using the VIP address. I understand source groups need to be defined for this requirement to NAT the source ip address of server. There is also a requirement to send traffic t...

Hello all,I must configure our CSS to use a GeoTrust SSL wildcard cert covering 3 domain levels, i.e., "*.abc.com", "*.*.abc.com" and "*.*.*.abc.com".We generated the CSR from the CSS using "*.abc.com" for our domain name since you can only make one ...