Application Networking

Well the questions keep coming.Can anyone point me in the right direction for setting up multiple SSL terminations, 443 port for them all and multiple VIPS. So far I have one SSL site working but when i try to make my 2nd ssl proxy list active it say...

I am attempting to capture all command line input to syslog for audit purposes.However, using the documented approachlogging subsystem netman level info-6 logging commands enable logging host 128.30.33.165 facility 1 log-level info-6 I also get lines...

Well, I was able to get the 11506 to proxy to different webservers based on URL statements. Now I am testing SSL reverse proxy. I have the SSL module installed. So I have one web server on port 80 behind the CSS. https://www.test.com resolves to the ...

If Cache Engine use spoof mode, how ACE be configured for support this mode. Have it any command add into ACE?

Hi, is there a command to suspend all content rules on a CSS. I need to reconfigure my redundant-vips. But it will not allow me to do so as long as the content rules are active.I would like to move from 8 virtual routers to one and assign multiple vi...

Alright, I have a CSS11506 in the lab and I am trying to configure it into a reverse proxy config. So I would like to have all inbound http requests hit the CSS and then have it redirect to our web server on correct DMZ. Having never setup a CSS befo...

I am trying to run the ap-kal-httptag "Hostname WebPage HostTag"I am putting in script play ap-kal-httptag "192.10.19.12 /Livelinksupport/chicklet.png" and I getUsage: ap-kal-httptag "Hostname WebPage HostTag"What is the HostTag?I have a CSS11506 wit...

hi guys,please i have configured this keepalive and service as shown:keepalive Server-1 type http port 81 method get uri "/HealthCheck2/HealthPageTest/Default.aspx" ip address 10.0.207.71 active service Server-1 ip address 10.0.207.71 port 81 keepali...

Hi,I am trying to acheive a reliable keepalive mechanism which mimics a HTTP user authenticating with the service, but the service port is 7002.I have looked at the above script (port 80), what do I need to do to enable this to happen under the 'serv...

Hi,I am trying the simplest of configurations, attempting to Load-Balance traffic using two servers and a single CSS. I am using "Routed" mode, but am experiencing problems with NAT. I am new to the world of CSSs. I have two servers that have the VIP...

Hi i wan't to configure VRID Peering on the following configuration:circuit VLAN89 ip address 195.177.246.120 255.255.255.128 ip virtual-router 101 priority 210 ip virtual-router 102 priority 210 ip virtual-router 103 priority 210 ip virtual-router 1...

Hi All,I have a very simple SLB configuration on my 6509 switch running IOS. I tried moving the configuration from IOS to the CSM Module. I did this by simply removing the ip slb commands and writing the same configuration under module CSM #. Once th...