Application Networking

Hello,I have a Cisco CSS11501 Content Switch.I am attempting to Load Balance SIP traffic, (the CSS support SIP according to data sheet)The idea being that the content switches ammend the IP headers BUT ALSO look deep into the packet and also ammend t...

Hi to allour loadbalancer is attached to a firewall with multiple interfaces. I configured policy based routing on the loadbalancer so that based on the source Ip Adress the Loadbalancer chooses the right interface on the firewall. This configuration...

We have a need to terminate multiple SSL websites on our CSS. So name1.test.comname2.test.com, name3.test.com etc. The problem I have found is that I need to burn 1 public VIP per SSL connection b/c they all need to use tcp 443 inbound and point to t...

what training is required for the module "Cisco? Application Control Engine (ACE) family for the Cisco Catalyst? 6500"?thanks

Again another newbie CSS question. But now that I have the CSS terminating both SSL connections for my backend web servers. Is it possible to move the servers off the same subnet as the CSS (public zone) and move them back into my production LAN whic...

is possible to debug the load-balancing decision which is provided by ACE? For example: when the traffic comes to the VIP address I need to see which serverfarm is used for this traffic and which rserver was choosen for this traffic. Thank you.

Hi Sir,Referring to the Cisco Catalyst 6500 Series Content Switching Module (CSM) (part number: WS-X6066-SLB-APC), it supports a maximum of 512 VLANs.From most of the config examples I came across, when the CSM is configured for secure (router) mode,...

service C1 ip address XXX.XXX.29.130 activecontent Test2 vip address XXX.XXX.29.143 protocol tcp add service C1 activegroup clients-group vip address XXX.XXX.29.143 add destination service C1 activeIn XXX.XXX.29.130 not view user IP ...

I have a request to load balance multiple instances of an application on one server. This application would be run on two servers but the requirement is to load balance 3 instances of the same application (on different ports) on the same server.How s...

So still terminating 2 ssl websites on CSS, with http connections to the backend servers. Do I need to also add an http content rule for the CSS to backend server connections in addition to the SSL content rule ?