Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm looking for a way to configure a CSS to direct traffic to "overload" servers when the number of maximun connections is reached for a service. Is this possible?Thanks,Ilona GlaserGerman Weather Service
Currently CSS terminates SSL connections for 2 backend web servers. Do these web servers need to be physically connected the CSS switch module ? Or can I move them to another segment of the network ?Right now the reverse proxy function stops working ...
Hello,Can anyone tell me what (if any) the limitations are on the CSS with regard to configured services, content rules, groups, etc...? Is there a documented maximum for each individual config variable or the sum of all config variables? I've also h...
Well the questions keep coming.Can anyone point me in the right direction for setting up multiple SSL terminations, 443 port for them all and multiple VIPS. So far I have one SSL site working but when i try to make my 2nd ssl proxy list active it say...
I am attempting to capture all command line input to syslog for audit purposes.However, using the documented approachlogging subsystem netman level info-6 logging commands enable logging host 128.30.33.165 facility 1 log-level info-6 I also get lines...
The next CSS questions I have is this.I have a need to have multiple web servers (port 80)on the backend behind the CSS. Each have a unique web service and URL.I need to be able to terminate all of the front end web connections via HTTPS. Now obvious...
Well, I was able to get the 11506 to proxy to different webservers based on URL statements. Now I am testing SSL reverse proxy. I have the SSL module installed. So I have one web server on port 80 behind the CSS. https://www.test.com resolves to the ...
Hi, is there a command to suspend all content rules on a CSS. I need to reconfigure my redundant-vips. But it will not allow me to do so as long as the content rules are active.I would like to move from 8 virtual routers to one and assign multiple vi...
Alright, I have a CSS11506 in the lab and I am trying to configure it into a reverse proxy config. So I would like to have all inbound http requests hit the CSS and then have it redirect to our web server on correct DMZ. Having never setup a CSS befo...
I am trying to run the ap-kal-httptag "Hostname WebPage HostTag"I am putting in script play ap-kal-httptag "192.10.19.12 /Livelinksupport/chicklet.png" and I getUsage: ap-kal-httptag "Hostname WebPage HostTag"What is the HostTag?I have a CSS11506 wit...
hi guys,please i have configured this keepalive and service as shown:keepalive Server-1 type http port 81 method get uri "/HealthCheck2/HealthPageTest/Default.aspx" ip address 10.0.207.71 active service Server-1 ip address 10.0.207.71 port 81 keepali...
Hi,I am trying to acheive a reliable keepalive mechanism which mimics a HTTP user authenticating with the service, but the service port is 7002.I have looked at the above script (port 80), what do I need to do to enable this to happen under the 'serv...
Hi,I am trying the simplest of configurations, attempting to Load-Balance traffic using two servers and a single CSS. I am using "Routed" mode, but am experiencing problems with NAT. I am new to the world of CSSs. I have two servers that have the VIP...
Hi i wan't to configure VRID Peering on the following configuration:circuit VLAN89 ip address 195.177.246.120 255.255.255.128 ip virtual-router 101 priority 210 ip virtual-router 102 priority 210 ip virtual-router 103 priority 210 ip virtual-router 1...
