Application Networking

I've configured vip redundancy on a pair of 11506. I would like critical services defined to failover when ALL the services are down or the upstream gateway is down. The documentation isn't very clear on this. There are simple examples and only the o...

HiI am new to CSS and am interested as it might be able to provide a solution to a problem I have seen.We currently have 3 Windows Servers running an ASP-based web application with a clustered SQL Server backend. The front end uses windows load balan...

Hello,I'm looking to add a 3rd GSS to my GSS network. If we configure it as a standalone GSS and then register it to the primary with the command:gss3# gss enable gss gssm1.domain.comAnd then go into gssm1.domain.com's GUI and Activate gss3 will gss3...

Hi,We have the following CCS 11500 with ssl offload.Version: sg0750103 (07.50.1.03)Flash (Locked): 07.20.0.03Flash (Operational): 07.50.1.03Type: PRIMARYLicensed Cmd Set(s): Standard Feature Set I was wondering if the following is possible :Environme...

I cannot find any document about RHI for css. Is it supported by css? Thanks.

Is there a switch on the commit_Redundancy or commit_Vipredundancy command to do just a compare of the configs? Or is there another way to do this?

I have an issue with two content rules balancing on ports 80 and 443. The port 80 rule works fine however the port 443 rule does not. If I remove the url "//webaddress.internal.domain.co.uk/*" statement from the port 443 rule or replace it with "/*" ...

I have configured 2x CSS 11503 according to the documentation for GSLB using DNS. Basically, there are 2 sites, Westcoast & Eastcoast. The west will be primary and the east will be secondary. Each site has one or more web servers serving the same con...

Hi to alli have a question regarding PBR on the CSS. I have a configuration with 4 VLAN (2 vlans are outside, eg vlan 3405 and vlan 3403) and 2 vlans are inside(vlan 3407 and 3410). I implemented PBR on the CSS so that i have 2 default route point to...

Hello,We are using a non-cisco WCCPv2 client with L2, mask assignment with 2 groups to redirect all TCP and UDP pkts.TCP wccp redirect-in on ingress vlan works perfectly (hw switched etc). But when we use redirect in for the udp group, udp pkts are n...