Application Networking

In this case,when I config CSM for load balance http and https service separately was ok.2 VIPs , 2 Serverfarms, One for http , and one for https .But I found that the https would referred to http information on IIS , because when the client first to...

We are currently experiencing session timeout problems with our oracle collaboration suite applications. We are using 2 x CSS11503 to load balance 2 VIP groups, using the one armed topology. The problem is very intermittent. When users are first sign...

Hi,We have a CE507 (version 2.x). Someone has tried to install Linux in the past over the CE507 SCSI drive. Looks like he succeeded. The issue is how to recover the situation back, so I can install the ACNS software on it.1. Should I format the HDD a...

I have a pair of CSS11500 with a pair of SCA behind them in one port mode. I want to monitor them with snmp for the uptime. I have setup a rule for this but udp port 161 is routed and not set up as a flow. Is there a solution for this?Here my content...

Hello.In a CSM, when a real server fails, the relative SNMP trap does not contain the ip address of the real server. Is it possible to set SNMP in order to have the IP Address of the real server inserted in the trap?Thanks.

Hi! One of the CSS11150 in our production CSS Pair has failed. If we reboot the box it displays following:Enter the number of a menu selection: Enter the number of a menu selection: 1* Set Boot Configuration 2. Show Boot Configuration 3* Advanced Opt...

Hello,I have the following problem after configuring/setting up tcp probe:probe TCP tcp interval 10 failed 30vserver test:3389virtual x.x.x.x tcp 3389serverfarm testinserviceserverfarm testreal a.a.a.ainservicereal b.b.b.binservicereal c.c.c.cinservi...

Hello,i've using Version 7.50 and using the SSL Module with Backend SSL.Now, i wanted to make my keepalive with an http Request on Port 80.With an script this seems to be possible, but i do not know if this is supported.Sven

i had install one CSS11501 which is balance the 3 websphere (webserver) server. the problem is when we used the CSS11501 for doing a load balance only certain user can access the webpage and certain user cannot access. this 3 servers are using https ...

Hi,I have two server A and B. A connects to B via a Load Balancer. It is also possible for A to connect to B directly.If A connects to B via the Load Balancer virtual IP (vip), which IP address will server B see ? Is it the VIP or ip address of serve...

Hi,I am trying to figure out what to send the CSS to have super-user authentication work.We are using free-radius. When I configure:virtual authentication primary radiusand run the radius server in debug mode (radiusd -fxx)I see that the CSS contacte...

I have a ssl module just installed. and tried to configure ssl termination.followed the quick start, after generate a rsa key and associated the key into a file, I have run ssl gencsr.the next step is to send the output to a CA. I have tried to find ...

Hi, All,I'm software engineer and has no idea about CSS. In one of our project, the hardware guys use CSS 115xxx to load balancing some of our servers for HTTP request(not web request). The servers will shut down one by one each hour to do some maint...

Hi there,We are running in bridge mode, and are having some weird arp table issues. I think I have it traced down to the fact that the CSM is arping for addresses, and the replies are getting to the CSM and getting cached, but the MSFC is never seein...