Application Networking

This is the message everytime I try to sync the cards.NETCSP01#hw-module contentSwitchingModule 5 standby config-syncConfiguration Sync is not supported by this cardNETCSP01#The are both installed into the same 6513.Here are the configsmodule Content...

Hi All,My DOS volume is full. I need to erase it, but am worried I will end up erasing the Cisco IOS on the drive as well....The whole caching engine thing is a bit confusing.Can anyone offer some insite as to how the disk partitions work and how to...

We are configuring NTLM authentication in our CE507. When configuring NTLM, we recieved some errors(attached). I would like to ask what causes the error messages and what needs to be done. Any feedback will be highly appeciated.Regards, udimpas

HiI have connections coming in to a VIP which is load balanced with a CSS between web servers. However I need the web servers to talk to a VIP on the same subnet and then load balance that to servers in the same subnet as my web servers. We are using...

Can I apply multiple ACL to a VLAN.thanks.

hi all,we noticed considerable longer response times for https-sessions using advanced-balance ssl than accessing the server directly. we use a css 11501 (without ssl module) and in the worst case we see about 3-4 times longer response times with the...

Is there a way to share a VIP between 2 physical sites? That is, to have one CSS advertise the VIP to OSPF, and the other (standby) CSS conditionally advertise the same VIP (w.x.y.z /32) only if the active CSS is down, or the keepalives on the servi...

I'm needing some help. I'm trying to set up a rule on a CSS11506 to run sticky SSL and provide a redirect if the services are unavailable. I have the following:content rule-90 add service appserver1 add service appserver2 add service appse...

I'm needing some help. I'm trying to set up a rule on a CSS11506 to run sticky SSL and provide a redirect if the services are unavailable. I have the following:content rule-90 add service appserver1 add service appserver2 add service appse...

Hi,I'm trying to use the CSM server farm backup feature with additional thresholds (inservice and outservice) configurations.I think I've done the configuration well, at least from what I could understand from the available docs.Nevertheless, the ins...

Hello,We have a running CE507 ver.5.0.5 for caching and SmartFilter ver3.1.2 for URL filtering. Our smarfilter is cuurently running to authenticate users HTTP trafic by IP address. We've been trying to configure the CE507 and smartfiter to authentica...

Hi, I have two service provider with access to Internet and I like load balancing this links.... Is possible ?for example, service provider 1 only HTTP and service provider 2 all not HTTP. ¿?

HIIs there a way to specify cache engines as primary and secondary when using WCCP?I have 3 caches joined to one router, and I need to specify one as primary since the others are a few router hops away.rgdsMatt

We currently have an environment with CSS running in routed mode. We are building a new data center with 6509s and CSM-S. My question is what is the best mode to run the CSM-S in routed or one-arm and why?