Application Networking

Our customer uses your product(CSS) for balancing loading over several servers where some website is working. This website requires login for users. To handle user session between users requests Tomcat session mechanism is used.But sometimes while wo...

In the attached config, is possible for the css to have content rule that does not at least contain the same port as the service rule. This does not seem right without some special configuration.

Hi,I need some help to troubleshoot a problem I'm having. I have a CSS 11000 and I should start by saying that I have a very basic knowledge on how to operate. On the CSS I'm getting the following error:DEC 21 10:20:35 5/1 6245 IPV4-4: ARP: could no...

I have a scenario where I have the same two servers (s1 and s2) being load balanced in two different content rules. One content rule is doing sticky based on an arrowpoint cookie, the other is using source ip as its sticky method.My question: Is the...

Hi,I have CSS 11501 V7.50When I sent to VIP IP bigsized packet (65k) I get no response.First, I tested with ping.I sent ping sized 1600. Request time out.Then I sent ping sized 1473 request time out.When I sent ping sized 1472 I can got request. (On ...

We have the follow configuration:ip slb serverfarm MMS_BOX nat server failaction purge probe MMS_PING ! real 10.10.1.39 weight 100 faildetect numconns 3 numclients 1 inservice ! real 10.20.1.201 weight 20 faildetect numconns 3 numclients 1 inse...

I am running two CSS 11501's (running 7.40) attached to two Catalyst 3550's (running 12.1(19)EA1).I have converted two of my interfaces from bridging to trunking on my CSS. There is an in-built bridge loop for network resiliency. The CSS's are conn...

On a CSM v4.2(3) on a 6509: I'm trying to make the real servers have names (like on the local director) instead of IP addresses:VOC-SW15#conf tEnter configuration commands, one per line. End with CNTL/Z.VOC-SW15(config)#mod csm 4VOC-SW15(config-mod...

Hi,I have a CSM+SSL module in a 6506 switch. I can'nt get the CSM and SSL module to communicate at the admin level.On the 6506 I have created a vlan and vlan interface to communicate with the SSL.interface Vlan60 description : Management Vlan for SSL...

When a CSM is deployed in a bridged mode configuration with the MSFC located toward the client-side, is source NAT still required for server-side server to VIP communications?Or does the CSM automatically snoop/intercept the return traffic and direct...

2 physical servers are configured as servies on 11501. The CSS is configured as a "one arm bandit"The entire organization can browse to the virtual IP, but the actual server can not. In fact, no server on the same L# network can browse to the VIP.I...

HiI have a 6509 with a CSM module and an SSL module installed. A section of the config is as follows (IP addresses changes for security): probe HTTP http request method get interval 5 failed 10 ! serverfarm SF7020 nat server no nat client pr...

Hello,I've a task to complete with communication between OracleAS and OracleAS Web Cache which resides on the same machine - OracleAS.I've found the description for such communication:---If an LBR is front-ending Oracle Application Server, it will ne...

We have array of Cache for Web-cache. It's load balancing by CSM. But we has big trouble grom our custommer.Our client needs to access to website: http://channel.telerate.com.sg. After authentication, it open port 6080 to download Java, but our custu...