Application Networking

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco UCS X-Series Energy Efficiency Offer

 

Forum Posts

        HI,I cannot understand the resource allocation of the ACE I have configured, in particular why the MAX allocation is lower than the MIN allocation, or even 0.Probably, it's related to the RC0 class, where the maximum is set as unlimited, but ...

asepiacci by Level 1
  • 1661 Views
  • 2 replies
  • 0 Helpful votes

Hi All,can you help clarify my understanding on how to configure SSL Acceleration..... I have do essentially do 3 things...1st, enable the SSL Accelerator under Accelerator Optimization (at both data centre and branch office WAAS Devices), but this w...

simmo by Level 1
  • 2477 Views
  • 2 replies
  • 0 Helpful votes

Hi All,I just swapped in a new WAAS appliance (WAVE-694-K-9) in place as part of an upgrade to swap out an older appliance.  I performed a replacement procedure as outlined in a Cisco doc.  The replacement and registering the new appliance to the Cen...

Hi All,I  just swapped in a new WAAS appliance (WAVE-694-K-9) in place as part of  an upgrade to swap out an older appliance.  I performed a replacement  procedure as outlined in a Cisco doc.  The replacement and registering  the new appliance to the...

Hi,I have ACE 4710. My users will be accessing websitewww.fcc.com which is mapped to VIP in DNS.My requirement is that when users access www.fcc.com then ACE should redirect the URL to the following onesDear Team,               Kindly create an new w...

I'm using an Ace 4710 Appliance deployed in One-Armed mode, using Source NAT to loadbalance HTTP request to a couple of Proxy servers.Everything is working fine, but the thing is that I can't see the Clients IP addresses on Proxy's logs, so I can't k...

jverdesca by Level 1
  • 3483 Views
  • 4 replies
  • 0 Helpful votes