Application Networking

Greeting,I tried to configure to allow system administrator use ssh to access WEB server.I did:acl 1clause 20 bypass tcp nql UWS eq 22 destination nql local-WEB-Farmapply circuit-(VLAN1)But, I still do not understand how the outside can ssh into web ...

Hello all,I have one CSM in two 6500 switches in active-passive configuration, in CSM inline mode. ( so the L3 inter-server communications go through the CSM with predictor forward)Here the details:- one CSM (4.1.5) in one C6509 switch with SUP2/MSFC...

Hi We have an 11150 with no software on the flash - deleted. We are in OFFDM and unable to upgrade via FTP. The device just reboots and before IP comes up returns the error:READING CONFIGURATION RECORDS FAILEDIt then goes straight back into OFFDM. Th...

Good day!after upgrade WEbNS to 7.50.1.03 services,which has script keepalive does not UP and return error "Script failed to load. Is script present on disk?". Although after reload with new WebNS all needed scripts was been uploaded to CSS. I see th...

Hi! I am a little bit confused about the configuration guides concerning csm + fwsm + csm bridged mode. in my opinion when using bridged mode with the csm i do not really need any alias ip configuration - neither in the client vlan nor the server vla...

HiI am planning to enable https for few web servers behind a CSS 11503. I have tested the functionality with the trial cert every thing works as desired. Now I need to buy a certificate from Verisign to make it work in production. At verisign they of...

Question 1:I have 2 exchange servers (EXCH A & EXCH B) and 2 fax servers (FAX A & FAX B). All servers are connected to CSS.When FAX A has mail to Exchange Server, CSS will randomly provide exchange server, let’s say EXCH A acknowledged the call. EXCH...

I know it's not possible to do ssl keepalives but I have the need to do more than port keepalives on a ssl web site due to the page failing at times. I'm about to implement back-end ssl with an ssl module and I'd like to make a keepalive to a html pa...

Hi we get troubles with our FTP Server. The clients send a Syn with Src port 40000 then the Server replies with the the same dst port but i presume that the loadbalancer makes a port-mapping and translate the source Port to eg. 33000. Our firewall cl...

Good day!Our HTTP services often down because of high load.I want to increase keepalive timeout.How possible to change keepalive timeout in services (not in script keepalive)?I tried do this via keepalive frequency as saying in http://www.cisco.com/e...

Hello to all,after studying architecture examples about Content Engine 510, I found that there is two modes:1) standard proxy2) transparent proxyI need the transparent architecture !But every example about transparent mode seems to include a router o...

Good day!We have standard config with ssl module and https content rule.But sometimes clients when trying connect to our server cluster via css and browser show "Page not found" after permitting ssl module certificate question.If refresh page - All i...

Okay, I've got a small issue that I think is a NAT problem. Could someone look over this config and tell if I've done something amazingly stupid? I can get to the load balanced addresses of 10.0.4.67:7080 and 10.0.5.98:8080 but NOT 10.0.4.68:8080 (no...