Application Networking

Hello, I apologize if this is a newbie question that has been asked a thousand times, but...I have inherited a one-armed setup (11501) with this unit out on a DMZ.It will be accessed both from the internet, and the inside network. (10.x.x.x)I have tw...

hello,we have two Cisco CSS wich loadbalance a MS Shreapoint farm with two servers. All works fine (http traffic). "Unfortently" with MS Sharepoint you can browse the documents via fileshare (SMB protocol). e.g. \\sharepoint-server\docs.So I have con...

trying to configure an additional secure http VIP on a css11503 running webns 7.4I've defined the second ssl service below:service ssl_serv2 type ssl-accel keepalive type none add ssl-proxy-list list2 slot 2however when I want to activate the service...

Hi,I have a GSS at each site serving pri and standby among them. Each site has got pair of CSS boxes providing HA.The issue is that the GSS boxes are not going for Syncing even though the GSSM-standby is configured with the ip address of its GSSM-pri...

What are some of the pro's and con's of WCCP and layer 4 switching. We currnetly are not using Cisco in our core and we are installing a new caching server.

After entering the below commands on my catalyst switch ip wccp 0 accelerated ip wccp 95 accelerated it produce the below eror and whole solution stopped working. The above command was used to reduce the CPU load on MSFC 4w4d: WCCP-EVNT:wccp_update_a...

hello,I wonder if anybody can explain how to load a script to run with CSS 11050.many thanksRaquel

We use the CSS to load balance terminal server sessions (TCP/3389). We used to have people getting disconnected all the time until we added flow-timeout 2700. Which I forget the conversion but is something like 12 hours. I'm wondering is there a bett...

I poll the 5 minute CPU load average through SNMP using the following OID: 1.3.6.1.4.1.2467.1.34.17.1.14.5.1 but it does not seem to me that is a 5 minute average, the vallue changes every second. Should I use a different OID? Τhe version is 6.10 Bui...

I have a CE510 and I also run SmartFilter. To a degree the caching has been more problems than what it is worth. I am constantly plagued by users having problems with forms, search sites, redirects, etc....I would like to turn off caching! I will be ...

I am having a routing problem (I believe) with my One-Arm Transparent Proxy configuration. When the SSL traffic (port 443) is sent to the CSS, the CSS forwards it off to the SCA on port 443. The SCA then forwards it back to the VIP on port 81 (verifi...

Could someone explain how to interput this command? Seems to me that the interval means to wait 5 seconds between pings, retry 3 times and wait 10 seconds before reporting a failure.5 x 3 = 15 (not 10). . . and then the receive 10 ????? No Idea.SLB#s...

I've got an 11503 with an SSL acceleration module. I've got it working, but I'm having a weird problem with pulling up images on page reload. I've tested this with multiple browser types (Firefox, IE, etc). When I pull up the SSL accelerated page, it...

Could someone shead light on the use of STICKY in reference to a virtual server.My config:sticky 20 netmask 255.255.255.255 timeout 300! policy FTP client-group CSMnets serverfarm FTPOUT! vserver FTPOUT virtual 0.0.0.0 0.0.0.0 tcp ftp service ftp vla...