Application Networking

07:46:00 5/1 327 SYSSOFT-4: IMM message not deliverable, message queue full, ce = 0x20203900, message type = 0x390007, message queue id = 0x85aac7a0I have many warnings in sys.log from SYSSOFT. I have found in the documentation following informations...

Hi all,I have configured the local director to load balance several web sites on two real servers. One of these sites is required to be configured in backup mode.For some reason the local director is unable to detect the site has gone down (by stoppi...

cat3512xl - c3660 ge / |CSS Fe0/12 ge \ | cat3512xl - 3620in above configuration i have problem with HSRP. It doesn't works beetwen routers. When i tune SPT to made FE link as primary beetwen CATs HSRP works fine but CSS stops seeing IP addresses of ...

I found this paragraph in the IOS 12.x documentation. The second sentence seems odd to me. Because WCCP redirection was enabled on a specific interface, it affects all interfaces on a router. Does it only affect interfaces that have an outbound redir...

The Backgrounda. One CSS load balancing x web servers. Very basic round robin load balancing.b. The CSS is within let say SubNet A - x.x.1.0 and is connected to an edge switch (Cisco 400x)c. Let term the other network (not in SubNetA) as the Other Ne...

I'm trying to configure SorroyServer Feature on a Content. It works, but once the original services fail the CSS always sends the connections to the SorryServer. I have found on the web this:After the CSS 11000 directs requests to a primary sorry ser...

I am new to this technology and I want to know what are advantages and disadvantages of Local director over the CSS and vice versa besides the price. What functionality does one has that is not supported by the other ?

What kind of overhead is introduced to CSS 11500 after configuration of access lists? I've tried looking on site but couldn't find relevant information.Thanks,Elena

We have a CE560 setup as a http proxy, our RealPlayer is configured to point to the CE using http not rtsp. We can stream video files but nothing seems seem to be cached on the CE. Does any one know if RealProxy is only way we can benefit from cachin...

I have two CSSes - first is master, second is backup. When I enable ACL on master CSS, it can't see more the backup CSS. My first rule is to allow all traffic between both CSSes. I have CSS 11050 with 4.10 Build 10.Here is a part of my config:--- beg...

On the LocalDirector 416 Load Balancer, if you type the "show connections" command, it lists the different types of connections that are currently being used, and the maximum number of each type that have ever been used at one time. Examples of types...

Question:if i have one CSS to connect to a redundant datacenter(two routers and two core switches), how do i configure it so that the css provides service to both networks ?regardsPT

Hi, I get this return when I issue a show system-resources commandSystem Resources for 7/1: Installed Memory: 67,108,864 (64 MB) Free Memory: 2,245,136 (2 MB) CPU: 0%Buffer Statistics: Buffer Pool: 0 Size: 256 Total:1000 Available:1000 Failures: 0 Lo...

Does anybody know a list of known problems with this device, a boot up scheme, a jumpers description ? My problem is that the device refuses to boot up. It lights first hdd led, then lights and turns off the second hdd led and leave itself in this co...

Hi All:I need to load balance 2 different web servers using sticky connections on a LocalDirector 416.I need to use cookie-passive mode, which of course relies on a cookie set by the web server.Problem: The name of the session cookie is different on ...