Application Networking

What is exact meaning of “Reap Conn” field in system message?2013 22:02:45 TEST: %ACE-6-302023: Teardown TCP connection 0x98d62 for vlan913:10.167.1.40/11612 (10.167.1.40/11612) to vlan316:172.18.41.205/7604 (172.17.16.19/7604) duration 0:00:02 bytes...

What is the best practice regarding interface speed and duplex issues when connecting a Cisco WAE appliance to a Nexus 7k.  Should both interfaces be set to auto/auto on both devices or should the speed and duplex settings be hard coded?

Good Afternoon,You are all probably aware by now of the discontinuation of the ACE product. Needless to say after defending the ACE from vendors such as F5, it is disappointing.However, life and load balancing must go on and the question is, where ne...

Hi I have just brought ACE module back online after it lost its configurations but some ft groups have ended up in cold state after primary ACE failed to replicate the configs. I understand ft groups go into cold state when keys and certificates are ...

Hi All,Can anybody help me to know what are all the phases in https connection establishment and what would be the approximate required for each phase?Regards,Thiyagu      

Hello All,Can anybody help me to know more about the command "insert-http IS_SSL header-value "ssl"?I know the above command ACE inserts a value ssl in the http header from ACE to the back end server.please throw some ideas/points to understand:1- Wh...

I have a requirement to configure WCCP on the Nexus 7K for redirection of traffic to a WAN optimiser. I have multiple sources and destination that require redirection and therefore multiple source and destination interfaces.To reduce configuration co...

Which way(s) would be the best and recommended way to software upgrade the WAE/WAVEs in remote sites?(1) push the software image to the WAE devices through CM, and reload the WAE through CM(2) copy the software image to the WAE using CLI and install ...

Hello,We can simultaneously use two methods of intercepting traffic on WAAS appliance?, for example PBR or WCCP and INLINE. Thanks, Jorgeas           

I have a CSS 11503 that we use to balance SIP calls(UDP) among our SIP servers.We have a content rule that balances the incoming traffic and a source group to NAT the outbound traffic. Both the content rule and the source group use the same IP addres...

How to include ? sign in webhost redirection string in cisco ACE ? i tried using [] and \ as per cisco doc but it is not working.Can anyone help? How to use [] and \ to include ? symbol