04-05-2011 03:33 PM
Hi guys
Is there a way to do this? I cant find anywhere how to configure the AAA parameters for the ACE CLI access using the ANM. I know where to configure AAA for the ANM access, but not for the ACE devices.
thx in advance!
Omar M
Solved! Go to Solution.
04-06-2011 07:31 AM
Hi Omar,
I'm afraid this is one of the few things that can only be configured through the CLI of the ACE.
Regards
Daniel
04-06-2011 07:31 AM
Hi Omar,
I'm afraid this is one of the few things that can only be configured through the CLI of the ACE.
Regards
Daniel
04-06-2011 08:01 AM
Thank you Daniel!
04-06-2011 09:27 AM
Another quick question!
Is there a way to change the interface that the ACE uses for TACACSs requests? Also, there's gonna be a request for each context right?
04-07-2011 04:34 AM
Hi Omar,
Is there a way to change the interface that the ACE uses for TACACSs requests?
The interface to be used for the AAA request is chosen based on the routing table, so, unless the server is in a vlan directly connected to the ACE, you can define which interface to be used by configuring a static route towards the server.
Also, there's gonna be a request for each context right?
The AAA configuration is done on a per-context basis, so, each context will handle connections arriving to it following its own configuration settings.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide