Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys..
We are having trouble using the console port of a switch configured with AAA. As far as I know, authorization is NOT enabled on the console port of the switches by default, and we do NOT have the "aaa authorization console" command, but som...
Hi, I have a C1111-40 Router running 16.10.1b IOS XE. I want to use the "specific license reservation" feature, but i just found a link that says it needs IOS 16.11.1a to work: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/smart-licensing/qsg/b_S...
Hi guys.. picture this 3 routers scenario: R1<-------->R2<-------->R3 R2 is using a BVI interface to bridge traffic from R1 to R3 (both routers configured in the same segment). I'm trying to tag some traffic from R1 to R3 using a policy-map, but have...
Hi guys! I have two quick questions:
Can you monitor non-sda devices with the Assurance module? And is there a restriction in the device models? (i'm looking to monitor a non-sda WLC).
If the answer to the previous question is yes, do you need to...
Hi guys.. im trying to translate the following legacy configuration to MQC, but im having trouble to do so:
interface Serial0ip address x x x ip flow ingress encapsulation frame-relay IETFno fair-queue *Command not supp...
No TACACS, but it fell back to local authentication. I ran a debug and it said something like "console user don't need authorization" or something like that, after authentication.
The emulation is working as suggested by the documentation, when conso...
Thanks for the input. Acording to documentation, the default is: no authorization in console port. Even if you explicitly try to configure it in the con 0 line with the "autorization exec XXX" you get an error saying the configuration is irrelevant w...
Hi guys! We have 2 WLC 5760 and one of them is a HA SKU and they HAVE to be in different buildings. Can we configure the HA SKU WLC as standalone and use mobility groups for redundancy? Is there a License issue in this scenario? Thanks in advance!
Thanks for the reply..We are using 3.2. But the documentation I've read is from 3SE:http://www.cisco.com/en/US/docs/switches/lan/catalyst3850/software/release/3se/qos/configuration_guide/b_qos_3se_3850_cg_chapter_0100.html#concept_C5D181A3EC4D4F5FA52...
