CSM FT setting

[fabio.marino]

Hi,

I need to discovery  members of a FT group set in a CSM LB.

I am on the Swicth_1 that is the standby and now I want to figure out which switch  is the primary.

Is there any useful command?

Thanks.

[Kanwaljeet Singh]

Hi,

Please use command:  show module contentSwitchingModule 4 ft detail

The modules in FT will have same FT GROUP ID and usually it is recommended to have a different VLAN assigned for FT heartbeat exchange as well. So you can check manually on the basis of FT group ID which two modules are using it.

Another command which can be useful is: #show module contentSwitchingModule all ft

Regards,

Kanwal

[Jorge Bejarano · Accepted solution]

Hi,

Cat6k-2# show module csm 4 ft

FT group 2, vlan 30

 This box is active

 priority 10, heartbeat 1, failover 3, preemption is off
 

http://www.cisco.com/en/US/docs/interfaces_modules/services_modules/csm/3.2/command/reference/s.html#wpxref93908

Jorge