I got below configurations.
!************************** SERVICE **************************
service server1
protocol udp
port 22015
ip address 172.20.117.71
active
!*************************** OWNER ***************************
owner com
content rule1
add service server1
vip address 192.168.1.10
protocol udp
port 464
active
!*************************** GROUP ***************************
group NAT
vip address 192.168.1.10
add service server1
active
When the server1 initiates outgoing telnet traffic (port 23), the CSS translates the source IP to IP address 192.168.1.10. Is this behavior expected?
As port 22015 is configured under the service server1, so I expect the CSS only performs NAT if the port of the connection is 22015.
Does that mean the CSS does not care about the port of the connection when performing NAT, but only the IP address?