cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
639
Views
5
Helpful
2
Replies

WAAS Central manager configuration

darkid123
Beginner
Beginner

Hi,

I'm trying to get my Central Manager going but I'm finding the documentation very confusing. I installed the image (WAAS-4.0.19.14-K9.bin) and when it comes up the first time, the appliance is in application-accelerator mode. So I change the device mode to central-manager, and reboot.

When it comes back up, it's in the correct state. However, it won't allow me to connect to it through port 8443. My routing is fine as I can get to the appliance and back no problem, but when I try to https://x.x.x.x:8443, it goes nowhere.

Also, when I have it configured as application-accelerator, I can log on through port 8443 no problem.

Any ideas? and would anyone point me to some quality documentation on the setup?

The docs i'm currently using are:

http://www.cisco.com/en/US/docs/app_ntwk_services/waas/waas/v4019/configuration/guide/waas4cfg.html

Thanks.

2 Replies 2

darkid123
Beginner
Beginner

Never mind...found it!

"cms enable" needs to be entered to start the server.

you got it...and if for some reason the GUI isn't working, first thing to check is if CMS is stopped.

Good luck!

Dan

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: