Application Networking

Hi Guys,i am facing an issue where my Appls is receiving more post request then what had been sent by the client.It was reported that Appls log 3 http post but client only submitted one request.To troubleshoot, does the CSS has the ablility to view H...

Does anyone has any idea on how to probe a redirect server. While doing the configuration the options for health monitoring / probing is not available.

LB type is configured as Sticky By Source IP, users are complaining that they are always routing to same server in pool irrespective of any timeout durations set in LB or server,My understanding is when they go through proxy all users in that company...

when displaying the optimisation graphs etc for devices the timezone is UTC, i can set the timezone to CMDlocal for each graph, but to do this for every graph on every device is long windedIs there a Global setting somewhere to do this? I can't find ...

Does anyone out there have the TCP connection statistics for the new WAVE appliances?

we have fwsm running in routed mode and behind it is the ace. the ace is in bridge mode.we try to connect a sever ove http and see a connection hitting fwsm and then the ace. in ace we can see a return packet from the serverfarm host but then the ret...

HiJust a short question. Is an ACE blocking traffic from a Source if the mac-address of that source is not in the ARP/MAC table? No security feature is enabled. The sniffer shows, that the packet is not going through. Other traffic works fine. So no ...

can someone help on this.I am a newbee to loadbalancer conceptswe are going to have a setup like this:we have 2 application servers and 2 ISA proxy servers.we need to load balance these 2 servers using load balancer.Q1::can we load balance the 2 serv...

Anyone run into this? If you look at the topology under the core WAE's, there is nothing but mac aadresses. However under the edge devices it sees the the cores fine. I am running into optimization issues, CIFS is not working and I cannot pre-pop ath...