based on you setup, and considering 6500 doing redirection rather than routers (we can also build setup where router will act as WCCP server and take role of traffic redirection, and 6500 is only used a L2 media between router and WAE), belows is the best recommendation for 6500---
assignement method----mask (reduce it from default value to satisfy our need and save TCAM resource)
interception--in direction (61in ,62 in)
Abve combination will fully supported in H/w.
And yes gig0/1 and gi0/0 can be configured as etherchannel
In the previous article, we have seen, how to assign IP Address to Cisco UCS Management Interface. This way we gain access to the on-board management software called Cisco Integrated Management Controller (CIMC).
The next step of building UCS Server ...
How does everyone feel about service graphs in a brownfield network centric cutover? maybe I'm an old school engineer but I was taught that if you have to do a Pbr then your design is wrong. they are a pain to troubleshoot because you always f...
To participate in this event, please use the button to ask your questions
This special event - formerly known as Ask the Expert- is open only to Cisco Customers and Partners.
Many pages in the Cisco Community are acce...
Going to Cisco LIVE EMEAR 2020? Give your Data Center agenda a boost with these top recommended sessions. Register and join us!
Data Center Networking:
From Reactive to Proactive NetOps With Cisco Network Assurance and Insights- The Power of Data...