Application Networking

Hi,The installation of an ACE-4710 throughput upgrade license licence (ACE-AP-02-UP1) failed with an error message :CH01AC03/Admin#  license install disk0:ACE20111213081741975.licInstalling license... failed: No space left on deviceWhat could be the ...

Hi all, wonder if you can help me here - perhaps messed up in termilogy .We are in the situation we have a active configuration with ACE30 doing normal loadbalancing in routed mode, we have tons of rservers going out on a VIP.we now had to add a new ...

      Has anybody heard of Cisco's ceasing on developing the ACEs past ACE30?Thanks.

                   Hi,Can anyone explain how the ASA to handle non-load-balancing traffic (not classified with class-map)? It will be dropped or forwarded?Thanks

Hi, I have two ACE working on active-standby mode, I have one context configured on bridge mode, with two vlans, the client (vlan 100) and server (vlan 101) sides.I need to balance another service for two servers (different from the ones on the first...

Hi,We have a router 3845 with a WAE-522-K9. Eventually we have received notifications about "session limit" and we got this:Current Active Optimized Flows: 790Current Active Optimized TCP Plus Flows: 790Current Active Optimized TCP Only Flows: 0Curre...

I have an ACE 30  running in routed mode with 2 client vland and 2 server vlans.  I need to allow servers from server vlan 1 to talk to servers on server vlan 2.  How do you configure that?Thank youTony.

Hi Friends,I have a requirement, where I would like to monitor the WCCP Events through the monitoring systems (Open NMS Server) we have in place. I could see from the Cisco documents that there are no direct MIB's or RFC's available. Can you please c...

Hi,Recently i have implemented cisco wave 274 - k9 in our branch office, the site is up and running. but the main challenge we are facing is unable to by pass the WAVE when any power issue with the same.I have tried some BIOS setup option,no luck. pl...

Hi,We are using several contexts for each customer in our ACE module.One of the customer contexts needs to activate XML API to control their services.I've tried to activate it, but cannot get any http response, what can be missing?ACE10 version A2(3....

I am doing End-To-End SSL from ACE to Servers with Certs on the backend. The My probe is set to ssl version all and query's port 443 but fails when it see's the cert on the server itself with "Bad Certificate Error" so the probe fails. (This shows up...

Hi All,I'm working on task to update the SSL certificate for an application.Can anybody help me to know on the steps to upgrade the SSL, stuffs need to be checked before and after the installation and how to verify the new certificates.Regards,Thiyag...